9-217
P0916, P0917
EAS20611
P0916, P0917
EAS33091
TROUBLESHOOTING
Item
• [P0916] Gear position sensor: open or ground short circuit detected.
• [P0917] Gear position sensor: power short circuit detected.
Fail-safe system
• Able to start engine
• Able to drive vehicle
Procedure
1. Connection of gear position sensor coupler.
• Check the locking condition of the coupler.
• Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
2. Connection of ECU coupler.
• Check the locking condition of the coupler.
• Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
3. Wire harness continuity.
• Disconnect the gear position sensor coupler “1” and ECU coupler “2”.
• Open circuit check
Is the coupler condition normal?
YES
→ Go to step 2.
NO
a. Connect the coupler securely or replace the wire harness.
b. Turn the main switch to “ON”, and then check the condition of the DTC using the malfunction
mode of the YDT.
Is it in the “Recovered” condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 2.
Is the coupler condition normal?
YES
→ Go to step 3.
NO
a. Connect the coupler securely or replace the wire harness.
b. Turn the main switch to “ON”, and then check the condition of the DTC using the malfunction
mode of the YDT.
Is it in the “Recovered” condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 3.
To Next Page
Loading...
