9-243
P1806, P1807
EAS20623
P1806, P1807
EAS33103
TROUBLESHOOTING
Item
• [P1806] Shift sensor: open or ground short circuit detected.
• [P1807] Shift sensor: power short circuit detected.
Fail-safe system
• Able to start engine
• Able to drive vehicle
Procedure
1. Connection of shift sensor coupler.
• Check the locking condition of the coupler.
• Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
2. Connection of ECU coupler.
• Check the locking condition of the coupler.
• Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
3. Wire harness continuity
• Disconnect the shift sensor coupler “1” and ECU coupler “2”.
• Remove the joint coupler cap “3”.
• Open circuit check
Is the coupler condition normal?
YES
→ Go to step 2.
NO
a. Connect the coupler securely or replace the wire harness.
b. Turn the main switch to “ON”, and then check the condition of the DTC using the malfunction
mode of the YDT.
Is it in the “Recovered” condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 2.
Is the coupler condition normal?
YES
→ Go to step 3.
NO
a. Connect the coupler securely or replace the wire harness.
b. Turn the main switch to “ON”, and then check the condition of the DTC using the malfunction
mode of the YDT.
Is it in the “Recovered” condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 3.
To Next Page
Loading...
