2-30
CABLE ROUTING
1. Bracket
2. Handlebar switch coupler 2 (left)
3. Handlebar switch coupler 1 (left)
4. Radiator fan motor coupler
5. Immobilizer unit coupler
6. Brake hose
7. Radiator fan motor lead
8. Wire harness (to front turn signal light (right)
and oil pressure switch)
9. Front wheel sensor coupler
10. Wire harness (to handlebar switch (left))
11. Wire harness
12. Intake air temperature sensor coupler
13. Intake air temperature sensor
14. Radiator fan motor coupler (radiator side)
15. Immobilizer unit coupler (main switch side)
16. Immobilizer unit coupler (wire harness side)
17. Frame
18. Coupler cover
19. Protector
20. Hook-and-loop fastener (loop side) (white)
21. Hook-and-loop fastener (loop side) (black)
22. End portion of sponge protector
23. Hook-and-loop fastener (hook side) (black)
24. Main switch coupler
A. Route the radiator fan motor lead between
the brake hoses and frame.
B. Route the wire harness (to front turn signal
light (right) and oil pressure switch) between
the brake hoses and frame.
C. Route the handlebar switch lead (left) on the
rear side of the wire harness.
D. Insert the clamp into the hole of the coupler
cover.
E. Insert the radiator fan motor coupler into the
hole of the coupler cover.
F. Insert the immobilizer unit coupler into the rib
of coupler cover.
G. Cover the protector with the main switch
cover.
H. Make sure that the main switch coupler does
not protrude from the end portion of sponge
protector.
I. Align the mating surfaces on the hook-and-
loop fastener end (hook side) and hook-and-
loop fastener end (loop side) (black) and
wrap the wire.
J. Insert the handlebar switch coupler 2 (left)
into the hole of the coupler cover.
To Next Page