B95W
Operation
07_Bedienung_en.fm - V1.0 - 1.8.17
215 / 306
7
26
Hydraulic oil filter Notice
• When the hydraulic oil is cold,
the hydraulic oil filter clogging
indicator may light up briefly.
It will go out once the operating
temperature is reached.
Change the filter element; if
necessary identify the cause of
clogging.
Put gears into
neutral
Accelerate slightly and allow the
machine to roll until the
preselected gear setting is
reached.
J Refer to the section “See chapter
“Apportionable driving with
rocker acceleration pedal
(excavating mode)”.”.
Coolant temperature
Stop work.
Allow the engine to cool down
and idle with no load.
Shut down the engine after it has
cooled down.
Clean the filter by switching on
the reversible fan.
Low fuel level
Refuel the machine.
Overload warning
indicator
Set down the load.
Notice
Consult the operating instructions of the engine manufacturer for all fault
messages concerning the engine.
Symbol Name Required actions when lit up
To Next Page
Loading...
