YASKAWA SIGMA-7 Series User Manual

3.4 Position Correction Table Settings
3.4.3 Setting Method with the SigmaWin+
3
Position Correction Table
3-13
Initializing the Position Correction Table
Use the following procedure to initialize the Position Correction Table.
1. Click Initialize in the Function Group.
2. Click the OK Button.
3. Click the OK Button.
When the cursor is positioned on Initialize in the window, the “The SERVOPACK parame-
ters are returned to the default settings” message will be displayed, but the parameters
will not be initialized.
The Position Correction Table will be initialized.
Information

YASKAWA SIGMA-7 Series Specifications

General

Encoder Resolution	24-bit absolute encoder
Pollution Degree	2
Cooling Method	Natural cooling or forced air cooling
Control Method	Vector control
Communication Protocols	EtherCAT, MECHATROLINK-III
Input Voltage	AC 200 V, AC 400 V
Rated Output	Varies by model
Safety Function	STO (Safe Torque Off), SS1 (Safe Stop 1), SS2 (Safe Stop 2), SLS (Safely Limited Speed), SBC (Safe Brake Control)
Power Supply Voltage	AC 200 V, AC 400 V
Rated Output Current	Varies by model
Protection Functions	Overload, overvoltage, undervoltage, overheat, short circuit
Operating Temperature	0°C to 55°C
Storage Temperature	-20°C to 65°C
Vibration Resistance	5.9 m/s² at 10 Hz to 55 Hz
Ambient Humidity	5% to 95% RH (non-condensing)
Altitude	Up to 1000 m
Installation	Panel mounted