3.4 Position Correction Table Settings
3.4.3 Setting Method with the SigmaWin+
3
Position Correction Table
3-17
Reading a Position Correction Table File
Use the following procedure to read a Position Correction Table file.
1.
Click Import in the File Group.
2.
Select the file to read and click the Open Button.
This concludes the procedure to read the Position Correction Table from a file.
When the cursor is positioned on Import in the window, the “The parameters file is read
to the display” message will be displayed, but the parameters will not be read.
The Position Correction Table is read from the file.
To Next Page
Loading...
