YASKAWA SIGMA-7 Series

3.4 Position Correction Table Settings
3.4.3 Setting Method with the SigmaWin+
3
Position Correction Table
3-15
Reading the Position Correction Table from the SERVO-
PACK
Use the following procedure to read the Position Correction Table from the SERVOPACK.
1. Click All Parameters in the Read from Servo Group.
2. Click the Yes Button.
This concludes the procedure to read the Position Correction Table from the SERVOPACK.
Parameter will be used in the dialog box, but parameters are not read from the SERVO-
PACK.
The Position Correction Table is read from the SERVOPACK.
Information