App-50
IM AQ6370D-01EN
Appendix 7 Soft Key Tree Diagram
The following is an overview of the instrument's menus.
Some menus are omitted.
SWEEP
Auto sweep (5.1, 10.5)
Repeat sweep (5.13 to 5.15, 5.18, 5.19, 7.11)
Single sweep (5.13 to 5.15, 5.18, 5.19)
Sweep stop (5.13, 5.15)
Segment measuring (5.13)
Segment unit setting (5.13)
Sweep between line markers (5.14)
Sweep interval setting (5.13)
CENTER
Center wavelength (frequency) setting (5.5, 7.11)
Measurement start wavelength (frequency) setting (5.5, 5.6)
Measurement stop wavelength (frequency) setting (5.5, 5.6)
Setting peak wavelength (frequency) as the center wavelength
(frequency) (2.2, 5.5)
Setting THRESH 3 dB center wavelength (frequency) of measured waveform
to center wavelength (frequency) (2.2, 5.5)
For each sweep, setting the peak wavelength (frequency) as the center
wavelength (frequency) (5.5)
Setting the current waveform display scale as the measurement scale
for the next sweep (2.2, 5.5)
SPAN
Measurement sweep width setting (5.6, 7.11)
Measurement start wavelength (frequency) setting (5.5, 5.6)
Measurement stop wavelength (frequency) setting (5.5, 5.6)
Setting the sweep width as six times the RMS 20 dB width
of the active trace measurement waveform (2.2, 5.6)
0 nm sweep screen range measurement time setting (7.11)
Setting the current waveform display scale
as the measurement scale for the next sweep (2.2, 5.5)
To Next Page
Loading...
Need help?
General
