YOKOGAWA AQ6370D - SETUP

App-52
IM AQ6370D-01EN
SETUP
SETUP (1/2) SETUP (2/2)
3
4
5
6
7
8
2-1
9
12
9-1
9-2
9-3
9-4
9-5
1
2
10
11
10-1
10-2
10-3
10-4
13
14
1 Measurement resolution setting (5.7, 7.11, 10.5)
2 Measurement sensitivity, CHOP mode settings (5.9)
2.1 CHOP mode setting (5.9)
3 Averaging times setting (5.11)
4 Automatic sampling points setting (5.7, 5.8)
5 Manual sampling points setting (5.8)
6 Sampling interval setting (5.8)
7 Setting the measured wavelength to air/vacuum (5.2)
8 Sweep speed setting (5.10)
9 Pulse light measurement settings (5.15, 5.16)
9-1 Pulse light measurement OFF (5.15)
9-2 Peak hold time setting (5.15)
9-3 External trigger mode setting (5.16)
9-4 Gate mode setting (5.15)
9-5 Gate Signal Logic setting (5.15)
10 Trigger condition settings (5.16)
10-1 Edge setting (5.16)
10-2 Delay setting (2.2, 5.16)
10-3 Trigger input mode setting (5.16)
10-4 Trigger output mode setting (5.17)
11 Horizontal axis units setting (5.2)
12 Resolution correction function ON/OFF (5.7)
13 Smoothing (5.19)
14 Fiber connector setting (3.5)
Appendix 7 Soft Key Tree Diagram