Z3 Technology ZCube-21 - Page 59

ZCube-21 User Guide
DOC-USR-0253-01
______________________________________________________________________________________
Z3 Technology, LLC ♦ 100 N 8
th
ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702
59
(UDP/TSRTP/TSFILE
Only)
Video Max Delay*
(UDP/TSRTP/TSFILE
Only)
(300)
Sets encoder maximum video delay in milliseconds.
TS RATE
(UDP/TSRTP/TSFILE
Only)
125K – 20000K (5000K)
The overall bit rate of the transport stream.
Normally, this value should be set to 1.25 * (video
bit rate + audio bit rate). This can be set to higher
values to allow leeway for times when many bits
are needed to encode. This can be especially useful
for ensuring smooth playback at lower bit rates.
TS Lowlat Mode*
(UDP/TSRTP Only)
False
True
Selecting “True” causes the TS muxer to instead
send packets out as soon as it receives them rather
than buffering them. This results in lower latency
at the expense of decreased network efficiency and
a less smooth bitstream. There is a limit of 5Mbps
for TS Lowlat Mode.
Must be set to “False” for stream to be compliant
with ISO 13818-1 systems specification for transport
stream timing.
Authentication
(RTMP/RTSP/RTMPS
Only)
Disable
Enable
If authentication is required within the Wowza
streaming server, select “Enable” to enter user
credentials.
User
(RTMP/RTSP/RTMPS
Only)
Enter a valid Wowza user name.
Password
(RTMP/RTSP/RTMPS
Only)
Enter a valid Wowza password.
Text Overlay Enable
True
False
Enables display text over video.
Overlay Text
ENCDEV
Textbox for entering display text.
Overlay Location
Top Left
Sets screen location of display text.