Zeiss Axio Examiner - Page 77

OPERATION
Axio Examiner Docking station with TFT display Carl Zeiss
M60-2-0003 e 05/2012 77
User 4.3.6.2
Press the User button in the navigation bar to open the User page including five tabs: Mode, Buttons
left, Buttons right, Stand type and Language.
(1) Mode
This enables you to select between either the Standard mode or your Own settings.
In the standard mode, all functions are enabled as provided for in the as-delivered condition. If own
settings are selected, the settings will be enabled as defined by an administrator for the following control
elements:
− Five buttons at the right / left Z focusing gear.
To modify the button assignments, the operator needs to type in an administrator password.
Please carefully check who is given access to the administrator password. Arbitrary or random
changes to the button assignment may cause damage to both the microscope and the
specimen.
The factory-set password is "12345".
(2) Buttons left
To modify the button assignments, the operator needs to type in an administrator password.
Otherwise, the operator may only view the button assignments without being able to customize
them.
On this tab, you can configure the button assignments for the Z focusing gear. The control elements are
shown by icons. The two upper buttons and the two lower buttons at the Z focusing gear are configured
in pairs.
• Press the grey button to open the selection list.
• Use the ▲ ▼ keys to select the appropriate function from the list. The list will show only those
functions which are really available at the microscope.
• Press the Save button to assign the function. To close this window without making any selection,
press Cancel.
Use the same procedure for all other button assignments.
(3) Buttons right
To modify the button assignments, the operator needs to type in an administrator password.
Otherwise, the operator may only view the button assignments without being able to customize
them.
• To configure the button assignment, see the description for (2) Buttons left.
(4) Stand type
Not implied for Axio Examiner.