7-30
Measuring operation
61211-1020202 CenterMax Operating Instructions
Automatic probe change
A probe rack is required for automatic probe change. Preparations
have to be made prior to an automatic probe change.
• Allocate a storage position (holder).
A specific storage position in the probe rack must be allocated to
each probe. You should note which storage position is allocated to
which probe.
• Make sure that there is no collision during the probe change.
It is possible to define intermediate positions. This is done in order
to determine the path along which the probe moves to the storage
position.
The measuring software is required in order to carry out this proce-
dure.
• Please read the corresponding chapters in the operating instruc-
tions for the measuring software.
NOTE
To Next Page