Zeiss CenterMax - Safety Symbols on the CMM; Requirements for the Safe Use of the CMM

1-10
Introduction
61211-1020202 CenterMax Operating Instructions
Safety symbols on the CMM
The following symbols are attached to the coordinate measuring
machine (CMM) and the control cabinet.
Danger!
Any work on the control cabinet must be carried out only by an elec-
trical engineer.
Before opening the control cabinet, disconnect the control cabinet
from the power supply:
• Switch off the main switch – position "0“ – and secure it so that it
cannot be restarted.
• In case of plug connection:
Disconnect the power plug from the socket.
Danger!
Components in the control cabinet are still live, e.g. line filter, even
after switching off the main switch.
Requirements for the safe use of the CMM
In order to ensure safe operation of the coordinate measuring
machine (CMM), certain requirements must be met.
Observe the following:
• Always comply with the generally recognized accident prevention
regulations and safety instructions.
• Operate the CMM only with the protective devices provided for
that purpose.
• Do not remove any covers, protective equipment or warning
signs.
Danger symbol for electric voltage:
This symbol indicates a personal health
hazard of persons.
The symbol is attached to the front and rear
side above or below the door latch.
!
!
Danger symbol:
This symbol indicates a danger for persons and
the CMM and its components.
This symbol is attached to the CMM, the con-
trol panel or the control cabinet.