2-10
Description of the CMM
61211-1020202 CenterMax Operating Instructions
Standard control console
1 Control knob for speed adjustment
2 Joystick for the z axis and the rotary table (option); the joystick is
equipped with a push button for setting intermediate positions
3 EMERGENCY STOP button
4Keypad
5 Joystick for the x and y axis; the joystick is equipped with a push button
for setting intermediate positions.
EMERGENCY STOP but-
ton
The drives are switched off by pressing the EMERGENCY STOP but-
ton. Press the button to switch off the drives. The button engages. No
further travel movements are possible.
The button must be unlocked in order to switch the drives on again.
• Unlock the button by turning it.
Then the button is pushed up. The button is unlocked.
Operation of the joysticks
The joysticks are required for travel control. This applies to manual
and automatic probing. Prior to automatic probing, manual probing is
required to program the automatic measuring run.
Right joystick
x and y direction The right joystick is used to move the probe in the x and y direction.
The bridge moves in the y direction, the quill in the x direction.
1
3
2
5
4
To Next Page
Loading...
