1-2
Introduction
61211-1020202 CenterMax Operating Instructions
General information
Scope of delivery
The standard version of the CenterMax coordiante measuring
machine is delivered with the following components:
– Coordinate measuring machine (CMM)
– Control
– Control panel – standard version
– Computer with peripheral units
– Software – e.g. UMESS-UX
– Documents
– Probe system
– Master probe
– Reference sphere – for calibration of probes
– Temperature sensor – for measuring the workpiece temperature
– Temperature probe.
CE marking
The CE marking confirms the system's conformity with the basic
requirements of the following CE directives:
– Machinery directive 98/37/EC
– Low voltage directive 73/23/EEC
– EMC directive 89/336/EEC.
The fact that the CMM meets the above requirements is indicated by
the CE marking on its type plate.
To Next Page