2-22
Description of the CMM
61211-1020202 CenterMax Operating Instructions
– High-precision probing of specified positions.
Disc A disc is used for probing deep grooves and large holes. For large
holes, a disc offers the advantage of shorter travel paths as compared
with the sphere.
Principles for assembly
There are two ways to assemble a probe:
– Screwing technique
– Clamping technique
Preference should be given to the screwing technique.
Probes may be assembled individually. Probe kits with different com-
ponents are available.
Important!
The limiting values for probes must be observed when assembling
probes.
!
To Next Page
Loading...
