Start-up checklist
6-19CenterMax Operating Instructions61211-1020202
Start-up checklist
Clamping the workpiece
– Is the workpiece in the correct position? ➤ page 6-3.
– Is it possible to measure all workpiece dimensions in one cycle?
– Is measurement possible without collision? E.g. collision with the
probe rack.
– Is the workpiece clamped? ➤ page 6-3.
Switching on the CMM
– Has the CMM been switched on in the correct order? ➤ page 6-5.
– Is the power supply connected?
– Control cabinet switched on?
– Drives switched on?
– Operating mode selected?
– Computer switched on?
– Measuring software started?
Protective circuit for the driving forces
– Has the protective circuit been checked? ➤ page 6-8.
Probe assembly
– Have the criteria for probe assembly been observed? ➤ page 6-13.
– Have the limiting values for the probe been observed?
➤ page 6-14.
To Next Page
Loading...
