Tips for effective operation
7-31CenterMax Operating Instructions61211-1020202
Tips for effective operation
Changing the probe automatically
If several probes are required for workpiece measurement, you should
note which probe you have assigned to which storage position.
If you require more probes than can be accommodated by the probe
rack, it is possible to mount several probe racks on the measuring
table.
Do not switch off the CMM if ...!
The start-up procedure involves a number of worksteps which take a
while to perform. Furthermore, the CMM should be switched on 15
minutes before carrying out the first measurement. You can save time
by leaving the CMM switched on.
The CMM should not be switched off in the following cases:
– If it is operated during multiple shifts.
– If workpiece measurement takes several days and the CMM should
measure under constant conditions.
To Next Page
Loading...
