9-4
Maintenance and care
61211-1020202 CenterMax Operating Instructions
Care
Although the CMM is robust and easy to care for, a certain degree of
care is still required. The sensitive measuring system of the CMM
requires a certain degree of cleanliness. Even the smallest dust parti-
cles on the probe element or the calibration sphere may cause inaccu-
rate measurements.
Cleaning and checking Measures for care also include the regular cleaning and checking of
certain components.
For cleaning, you require:
– Mild detergent
– A fluff-free cloth, e.g. made of linen
– A vacuum cleaner
– If necessary, special solvent for removing aluminum deposits from
the probe element, e.g. KOH (10%).
Danger!
When carrying out care measures, make sure that no travel move-
ments are performed.
• Switch off the drives on the control cabinet in order to enable safe
execution of the care measures.
Important!
• Do not use compressed air for cleaning.
Use fat dissolving and non-corroding cleaning agents. We recom-
mend Clean from JVA. This cleaning agent can be ordered from us –
order no.: 84865.
Preventive care also includes making sure that all workpieces to be
measured are clean. The workpieces must be free from machining res-
idues (e.g. metal chips, oil) and dust.
• Clean the workpieces before placing them on the measuring table.
!
!
!
ss
NOTE
NOTE
To Next Page
Loading...
