Zeiss CenterMax - Page 138

8-4
Errors and faults
61211-1020202 CenterMax Operating Instructions
The CNC measur-
ing run cannot be
started.
MAN operating
mode set.
• Turn the key-operated switch on
the control cabinet to the AUTO
position.
Travel motion too
slow.
The set speed is too
low.
Increase the speed:
• Turn the control knob on the
control console clockwise.
The standard value,
e.g. 50%, set in the
measuring soft-
ware is too low.
• Set the standard speed value in
the measuring software to
100%.
The SLOW function
is active.
• Deactivate the SLOW function
via the control console.
Indication on the
control console
Probe change No storage posi-
tion allocated to
the probe.
• Allocate a storage position to
the probe.
Position of the
probe rack or stor-
age position was
changed.
• Reallocate storage position.
Collision:
missing intermedi-
ate positions.
• Reallocate storage position and
set intermediate positions.
Two probes allo-
cated to one stor-
age position.
• Reallocate storage position.
Fault Cause Measure Check