6-161211-1020202 CenterMax Operating Instructions
Chapter
.................................................................................................................................
6 Start-up
This chapter describes the work to be carried out regularly.
You want to clamp a new workpiece on the measuring table or pre-
pare the probe system for the measuring run? Or you want to switch
the CMM on again after it has been put out of operation? The follow-
ing pages provide the corresponding information.
Furthermore, the procedure for checking the protective circuit for the
drives is described.
This chapter contains:
Clamping the workpiece on the measuring table . . . . . . . . . . . . . . . 2
Switching the CMM on . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Checking the protective circuit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Mounting / changing the probe head. . . . . . . . . . . . . . . . . . . . . . . 11
Probe assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Inserting / removing the probe . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Start-up checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
To Next Page
Loading...
