ZONARE Z.ONE PRO - 4 SYSTEM SPECIFICATIONS; General system specifications

z.one
pro
Service Manual
Page 22 of 217
Diagnostic ultrasound is a technique-dependent imaging modality. To obtain the best possible patient care from
any ultrasound equipment, the system must be operated by personnel trained in ultrasound image acquisition
and interpretation. Users must become familiar with each of their imaging systems.
 Always make sure appropriate transducer is used for study being performed
 Always make sure active preset is appropriate for study being performed
 Know how to recognize acoustic artifacts in image
 Consult AIUM recommended protocols & equipment specifications
4 SYSTEM SPECIFICATIONS
This section contains system and accessory specifications. For information on the specifications for
ZONARE authorized peripherals, refer to the manufacturers’ documentation.
General system specifications
Type
Parameter
Value
Electrical
Power requirements
100-240V~, 50-60Hz, 6A max
Power consumption (no
peripherals – max)
180W (616 BTU/hr)
Power consumption (with
peripherals – max)
470W (1608 BTU/hr)
Environmental
(operating)
Cooling requirements
See power consumption above
Air temperature
0-35C (32 – 95F)
Humidity
15-80% noncondensing
Pressure
700-1060 hPa
Environmental
(storage)
Air temperature
-20-60°C (-4-140°F)
Humidity
15-90%, noncondensing
Pressure
500-1060 hPa
Physical
(weight)
z.one
pro
system
65.3 kg (144 lbs.)
Power cord
0.6 kg (1.4 lbs.)
USB printer & bracket
3.4 kg (7.6 lbs.)
Battery & bracket
4.1 kg (9.1 lbs.)
Operating weight subtotal
73.4 kg (162.1 lbs.)
System shipping container
41.5 kg (91.6 lbs.)
Total shipping weight
114.9 kg (253.7 lbs.)
Physical
(dimensions)
Height, max (in operating
use)
157.5 cm (62 in.)