Zte ZXR10 2900 Series - Page 172

ZXR102900SeriesUserManual
CommandFunction
zte(cfg)#setqospolicer<
policerid,0-255>exceed-action
{no-operation|drop}
Thisconguresthe
overspeeddisposalof
thetrafcmonitor .
14.TosettheglobalARPrate-limit,usethefollowingcommand.
CommandFunction
zte(cfg)#setqosrate-limitarp-All
{enable|disable}
Thissetstheglobal
ARPrate-limit.
�enable:ARPrate-limitisvalidforallarppackets.
�disable:ARPrate-limitisonlyvalidforthebroadcast
packet.
�Allthe100Mportsareenabledbydefault.
15.Tocongureingressratelimiton100Mport,usethefollowing
command.
CommandFunction
zte(cfg)#setbandwidthfeport
<portlist>ingresssession<0-3>rate
<64-100000>
Thiscongures
ingressratelimit
on100Mport.
Theparametersession<0-3>isconguredasfollowsbyde-
fault.
�0:broadcastsuppression
�1:multicastsuppression
�2:ratelimit
�3:usercongure
16.Tocongurepackettypeofportingressratelimiton100Mport,
usethefollowingcommand.
CommandFunction
zte(cfg)#setbandwidthfeport
<portlist>ingresssession<0-3>
packet-type{unknowmulticast|
broadcast|unicast|multicast|
MGMT|ARP|tcp-control|tcp-data|
udp|non-tcpudp}{enable|disable}
Thiscongurespacket
typeofportingress
ratelimiton100M
port.
17.Tocongurequeuetypeofportingressratelimiton100Mport,
usethefollowingcommand.
160CondentialandProprietaryInformationofZTECORPORATION