Zte ZXR10 2900 Series - Page 199

Chapter7ServiceConguration
CommandFunction
zte(cfg)#setethernet-oamport
<portlist>period<1-10>timeout
<2-20>mode{active|passive}
ThisconguresOAM
discoveryperiod,
timeoutrangeand
modeonport.
Theparameterperiod<1-10>:discoveryperiod,1represents
10ms.2represents20msandsoon.Bydefault,10represents
100ms.
Theparametertimeout<2-20>:timeout,bydefaultitis5
seconds
Theparametermode[active|passive]:discoverymode,it
isactivebydefault.
4.TostartorstopOAMremote-loopbackfunctiononport,use
thefollowingcommand.
CommandFunction
zte(cfg)#setethernet-oam
remote-loopbackport<portlist>{start
|stop}
Thisstartsorstops
OAMremote-loopback
functiononport.
Theprerequisitesofenablingthisfunctionisthattheglobal
OAMfunctionhasbeenenabled,theOAMfunctionhasbeen
enabledondestinationport,andtheOAMdiscoveryprocess
hasbeencompleted.
5.Tosetremote-loopbacktimeoutvalueonport,usethefollow-
ingcommand.
CommandFunction
zte(cfg)#setethernet-oam
remote-loopbacktimeout<1-10>
Thissetsremote-
loopbacktimeout
valueonport.
Theparametertimeout:thedefaultis3s.
6.Toenableordisablelinkmonitorfunction,usethefollowing
command.
CommandFunction
zte(cfg)#setethernet-oamport
<portlist>link-monitor{enable|
disable}
Thisenablesor
disableslinkmonitor
function.
7.Tocongurethesymbolperiodeventwhichisusedforlink
monitor ,usethefollowingcommand.
CondentialandProprietaryInformationofZTECORPORATION187