IES-1248-51/51A/53 User’s Guide
124 Chapter 16 xDSL Port Setup
Figure 59 xDSL Port Setting
The following table describes the labels in this screen.
Table 20 xDSL Port Setting
LABEL DESCRIPTION
Last Page Click this to return to the previous screen.
General Setup
Active Select this check box to turn on this ADSL port.
Customer Info Enter information to identify the subscriber connected to this ADSL port. You can
use up to 31 printable ASCII characters (including spaces and hyphens).
Customer Tel Enter information to identify the telephone number of the subscriber connected
to this ADSL port. You can use up to 15 ASCII characters (including spaces and
hyphens).
Profile Select a profile of ADSL settings (such as the transfer rate, interleave delay and
signal to noise ratio settings) to assign to this port. Use the Port Profile screen
to configure port profiles (see Chapter 17 on page 137).
Mode Select the port’s ADSL operational mode. Select the mode that the subscriber’s
device uses or auto to have the IES-1248 automatically determine the mode to
use. See Table 18 on page 119 for information on the individual ADSL modes.
To Next Page
Loading...
