ZyXEL Communications IES-1248-51 - Multicast VLAN Enable Command; Multicast VLAN Show Command; Figure 199 Multicast VLAN Disable Command Example; Figure 200 Multicast VLAN Show Command Example

IES-1248-51/51A/53 User’s Guide
340 Chapter 50 IGMP Commands
where
This command deactivates the specified multicast VLAN. The following example disables
multicast VLAN 12.
Figure 199 Multicast VLAN Disable Command Example
50.8.4 Multicast VLAN Enable Command
Syntax:
ras> switch igmpsnoop mvlan enable <vid>
where
This command activates the specified multicast VLAN.
50.8.5 Multicast VLAN Show Command
Syntax:
ras> switch igmpsnoop mvlan show <vlanlist>
where
This command displays the current multicast VLAN settings. In the state column, “-” indicates
the multicast VLAN is not active while “V” indicates the multicast VLAN is active.
Figure 200 Multicast VLAN Show Command Example
<vid> =
The multicast VLAN ID [1 – 4094].
ras> switch igmpsnoop mvlan disable 12
<vid> =
The multicast VLAN ID [1 – 4094].
<vlanlist> =
You can specify a single VLAN: <1>, all VLAN: <*>, a list of
VLAN: <1,3>, you can also include a range of VLAN:
<1,5,6~10>.
ras> switch igmpsnoop mvlan show 1
vid name F:fixed X:forbidden U:untag T:tag
---- ---------------- ----------------------------------------