ZyXEL Communications IES-1248-51 - MAC Count Enable Command; MAC Count Disable Command; Figure 179 MAC Count Enable Command Example; Figure 180 MAC Count Disable Command Example

IES-1248-51/51A/53 User’s Guide
Chapter 49 MAC Commands 325
49.3.2 MAC Count Enable Command
Syntax:
ras> switch mac count enable <portlist>
where
This command enables the MAC count filter on the specified ADSL port(s). When the MAC
filter accept mode is enabled (see Section 49.2 on page 321), the IES-1248 ignores the MAC
count setting and accepts all of the MAC addresses listed for the port in the MAC filter
settings.
The following example turns on the MAC count filter on ADSL port 4.
49.3.3 MAC Count Disable Command
Syntax:
ras> switch mac count disable <portlist>
where
This command disables the MAC filtering feature on the specified ADSL port(s).
The following example turns off the MAC count filter on ADSL port 4.
<portlist> =
You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Figure 179 MAC Count Enable Command Example
ras> switch mac count enable 4
<portlist> =
You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Figure 180 MAC Count Disable Command Example
ras> switch mac count disable 4