ZyXEL Communications IES-1248-51 - Log Messages; Table 94 Log Messages

IES-1248-51/51A/53 User’s Guide
290 Chapter 45 Command Examples
45.3.1 Log Messages
The following table lists and describes the system log messages.
<process> This is the process that created the log.
<type> This identifies what kind of log it is. "INFO" identifies an information log. "WARN"
identifies a warning log.
<log message> This is the log’s detailed information (see Table 94 on page 290)
Table 93 Log Format (continued)
LABEL DESCRIPTION
Table 94 Log Messages
LOG MESSAGE TYPE DESCRIPTION
ADSL <port> Link
Up(SN=<seq no>): <ds
rate>/<us rate>!
or
ADSL Link Info: NM:<ds
NM>/<us NM>!
INFO An ADSL port established a connection.
<port> - port number
<seq no> - sequence number of the connection
<ds rate> - downstream rate
<us rate> - upstream rate
<us NM> - upstream noise margin
<ds NM> - downstream noise margin
ADSL <port> Link
Down(SN=<seq no>)!
WARN An ADSL port lost its connection.
<port> - port number
<seq no> - sequence number of the connection
ADSL <port> Link Loss
of Power Dying-Gasp
Event!
WARN The subscriber device connected to an ADSL port experienced a loss of
power (Dying-Gasp).
<port> - port number
Change time server to
none.
INFO The time server setting was changed to none.
Change time server to
TIME. IP:<ip>
Timezone: <time zone>.
INFO The time server protocol setting was changed to TIME. The time server’s IP
address and time zone are displayed.
Change time server to
DAYTIME. IP: <ip>
INFO The time server protocol setting was changed to DAYTIME. The time
server’s IP address and time zone are displayed.
Change time server to
NTP. IP: <ip>
Timezone: <time zone>
INFO The time server protocol setting was changed to NTP. The time server’s IP
address and time zone are displayed.
External alarm is
triggered!
WARN External alarm input was detected.
Ether <port> Link
Down(SN=N)!
WARN An Ethernet link is down.
<port> - 1 is ENET1, 2 is ENET2
SN - an internal sequencer number
Ether N Link Up(SN=N):
<speed>!
INFO An Ethernet link is up.
<port> - 1 is ENET1, 2 is ENET2
SN - an internal sequencer number
<speed> - Ethernet connection speed, for example 1000M or 100M