ZyXEL Communications IES-1248-51 - IEEE VLAN1 Q Tagged VLAN Configuration Commands; VLAN Port Show Command; VLAN PVID Command; Figure 161 VLAN Port Show Command Example

IES-1248-51/51A/53 User’s Guide
314 Chapter 48 IEEE 802.1Q Tagged VLAN Commands
48.4 IEEE VLAN1Q Tagged VLAN Configuration Commands
These switch commands allow you to configure and monitor the IEEE 802.1Q Tagged VLAN.
48.4.1 VLAN Port Show Command
Syntax:
ras> switch vlan portshow [portlist]
where
This command displays the port’s IEEE 802.1Q VLAN tag settings.
The following example shows the settings for ADSL port 1.
48.4.2 VLAN PVID Command
Syntax:
ras> switch vlan pvid <portlist> <pvid>
where
This command sets a default VLAN ID for all untagged packets that come in through the
specified port.
[portlist] =
You can specify a single port <1>, all ports <*> or a list of ports
<1,3,enet1>. You can also include a range of ports
<1,5,6~10,enet1,enet2>.
Figure 161 VLAN Port Show Command Example
ras> switch vlan portshow 3
port pvid priority frametype
----- ---- -------- ---------
3 1 0 all
<portlist> =
You can specify a single port <1>, all ports <*> or a list of ports
<1,3,enet1>. You can also include a range of ports
<1,5,6~10,enet1,enet2>.
<pvid> =
The VLAN ID. Valid parameter range = [1 – 4094].