ZyXEL Communications IES-1248-51 - MAC Filter Enable Command; MAC Filter Disable Command; MAC Filter Mode Command; Figure 173 MAC Filter Enable Command Example

IES-1248-51/51A/53 User’s Guide
322 Chapter 49 MAC Commands
49.2.2 MAC Filter Enable Command
Syntax:
ras> switch mac filter enable [portlist]
where
This command turns on the MAC filtering feature on the specified ADSL port(s) or on all
ADSL ports if no port is specified.
The following example turns on the MAC filtering feature on ADSL port 5.
49.2.3 MAC Filter Disable Command
Syntax:
ras> switch mac filter disable [portlist]
where
This command turns off the MAC filtering feature on the specified ADSL port(s) or on all
ADSL ports if no port is specified.
The following example turns off the MAC filtering feature on ADSL port 5.
49.2.4 MAC Filter Mode Command
Syntax:
ras> switch mac filter mode <port> <accept|deny>
<portlist> =
You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Figure 173 MAC Filter Enable Command Example
ras> switch mac filter enable 5
<portlist> =
You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Figure 174 MAC Filter Disable Command Example
ras> switch mac filter disable 5