ZyXEL Communications IES-1248-51 - Alarm Profile Set Command; Figure 264 Alarm Profile Show Command Example

IES-1248-51/51A/53 User’s Guide
Chapter 55 ADSL Commands 395
The following example displays the default alarm profile (DEFVAL).
55.3.2 Alarm Profile Set Command
Syntax:
ras> adsl alarmprofile set <profile> [<atuc lofs> <atur lofs> <atuc loss>
<atur loss> <atuc lols> <atuc lprs> <atur lprs> <atuc ess> <atur ess> <atuc
fast rateup> <atur fast rateup> <atuc interleave rateup> <atur interleave
rateup> <atuc fast ratedown> <atur fast ratedown> <atuc interleave ratedown>
<atur interleave ratedown> <init fail enable> <atuc fail fast> <atuc ses>
<atur ses> <atuc uas> <atur uas>]
where
Figure 264 Alarm Profile Show Command Example
ras> adsl alarmprofile show DEFVAL
01. DEFVAL
ATU-C ATU-R
---------- ----------
Thresh15MinLofs (sec): 0 0
Thresh15MinLoss (sec): 0 0
Thresh15MinLols (sec): 0 ---
Thresh15MinLprs : 0 0
Thresh15MinESs (sec): 0 0
ThreshFastRateUp (bps): 0 0
ThreshInterleaveRateUp (bps): 0 0
ThreshFastRateDown (bps): 0 0
ThreshInterleaveRateDown (bps): 0 0
InitFailureTrap(1-enable, 2-disable): 2 ---
Thresh15MinFailedFast : 0 ---
Thresh15MinSes (sec): 0 0
Thresh15MinUas (sec): 0 0
<profile> =
A name for the alarm profile (up to 31 ASCII characters).
atuc =
Upstream. These parameters are for the connection (or traffic)
coming from the subscriber’s device to the IES-1248.
atur =
Downstream. These parameters are for the connection (or
traffic) going from the IES-1248 to the subscriber’s device.
<atuc lofs>
<atur lofs>
=
The number of Loss Of Frame seconds that are permitted to
occur within 15 minutes.
<atuc loss>
<atur loss>
=
The number of Loss Of Signal seconds that are permitted to
occur within 15 minutes.
<atuc lols> =
The number of Loss Of Link seconds that are permitted to occur
within 15 minutes.
<atuc lprs>
<atur lprs>
=
The number of Loss of Power seconds that are permitted to
occur (on the ATUR) within 15 minutes.