ZyXEL Communications IES-1248-51 - Chapter 54 SNMP; SNMP Commands; Get Community Command; Set Community Command

IES-1248-51/51A/53 User’s Guide
Chapter 54 SNMP 359
CHAPTER 54
SNMP
This chapter covers Simple Network Management Protocol (SNMP) with the IES-1248.
54.1 SNMP Commands
Use these commands to configure SNMP settings. See Chapter 37 on page 237 for more
information about SNMP.
54.1.1 Get Community Command
Syntax:
ras> sys snmp getcommunity <community>
where
Enter this command with the community to set the password.
54.1.2 Set Community Command
Syntax:
ras> sys snmp setcommunity <community>
where
Enter this command with the community to set the password.
54.1.3 Trusted Host Set Command
Syntax:
ras> sys snmp trusthost <ip>
<community> =
The password for the incoming Get- and GetNext- requests
from the management station.
<community> =
The password for the incoming Set- requests from the
management station.