ZyXEL Communications IES-1248-51 - Figure 283 RPVC Gateway Show Command Example; Figure 284 RPVC Gateway Delete Command Example; RPVC Gateway Delete Command; RPVC Set Command

IES-1248-51/51A/53 User’s Guide
Chapter 56 Virtual Channel Management 411
The following is an example.
56.7.4 RPVC Gateway Delete Command
Syntax:
ras> adsl rpvc gateway delete <gateway ip>
where
This command removes a gateway IP address that the device was set to use for 2684 routed
mode traffic.
The following example has the device remove a 2684 routed mode traffic gateway entry for IP
address 192.168.10.102.
56.7.5 RPVC Set Command
Syntax:
ras> adsl rpvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<ip>/<netmask> <gateway ip>
where
Figure 283 RPVC Gateway Show Command Example
ras> adsl rpvc gateway show
gateway ip vid
--------------- ----
192.168.10.102 1
<gateway ip> =
The IP address of the gateway to which you no longer want the
device to send the traffic that the system receives from this
PVC. Enter the IP address in dotted decimal notation.
Figure 284 RPVC Gateway Delete Command Example
ras> adsl rpvc gateway delete 192.168.10.102
<portlist> =
The port(s) of the RPVC.
You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
<vpi> =
The VPI of the RPVC.
<vci> =
The VCI of the RPVC.