ZyXEL Communications IES-1248-51 - Saving Your Configuration; Commands; Table 92 Commands

IES-1248-51/51A/53 User’s Guide
270 Chapter 44 Commands
44.3 Saving Your Configuration
Use the following command to save your configuration when you are done with a
configuration session.
ras> config save
Note: Do not turn off your IES-1248 while saving your configuration.
This command saves all system configurations to nonvolatile memory. You must use this
command to save any configuration changes that you make, otherwise the IES-1248 returns to
its default settings when it is restarted. Save your changes after each configuration session.
Nonvolatile memory refers to the IES-1248’s storage that remains even if the IES-1248’s
power is turned off. Run-time (memory) is lost when the IES-1248’s power is turned off.
44.4 Commands
The following table lists commands that you can use with the IES-1248.
The P column on the right indicates the administrator privilege level needed to use the
command (H for high, M for middle or L for low) and the equivalent in the web configurator
(H for high or L for low).
Table 92 Commands
CLASS COMMAND PARAMETERS DESCRIPTION P
sys
info show Displays general system
information.
L/L
info hostname <hostname> Sets the system name. M/L
info location <location> Sets location information. L/L
info contact <contact> Sets contact person information. L/L
passwd
reboot [show|sec|cancel] Sets the reboot timer or displays
the timer and remaining time for
reboot. If a reboot has been
scheduled, use this command to
prevent a reboot.
H/H
snmp show Displays SNMP settings. M/L
snmp getcommunity <community> Sets the SNMP GetRequest
community.
H/H
snmp setcommunity <community> Sets the SNMP SetRequest
community.
H/H
snmp trapcommunity <community> Sets the SNMP Trap community. H/H
snmp trusthost <ip> Sets the SNMP trusted host. Set
0.0.0.0 to trust all hosts.
H/H