ZyXEL Communications IES-1248-51 - Page 271

IES-1248-51/51A/53 User’s Guide
Chapter 44 Commands 271
snmp trapdst set <index> <ip>
[<port>]
Sets the SNMP trap server and
listening port. Set 0.0.0.0 to not
send any SNMP traps.
H/H
snmp trapdst del <index> Deletes the SNMP trap server H/H
server show Displays the device’s service
status and port numbers.
M/L
server enable <telnet|ftp|web|ic
mp>
Turns on a service. H/H
server disable <telnet|ftp|web|ic
mp>
Turns off a service. H/H
server port <telnet|ftp|web|ic
mp>
Sets a port for a service. H/H
client show Displays the device’s secured
client settings.
M/L
client enable <index> H/H
client disable <index> H/H
client set <index> <start ip>
<end ip> [[telnet]
[ftp] [web] [icmp]]
Sets a secured client set: a range
of IP addresses from which you
can manage the device and the
protocols that can be used.
H/H
syslog show Displays the syslog settings. M/L
syslog enable Turns on the syslog logging. H/H
syslog disable Turns off the syslog logging. H/H
syslog server <ip> Sets the IP address of the syslog
server.
H/H
stdio show Displays Current Stdio Timeout. L/L
stdio set <minute|0:no
timeout>
Sets Current Stdio Timeout. H/H
time show Displays the system’s current time. L/L
time set <hh> [<mm> [ss]] Sets the system’s time. H/H
date show Displays the system’s current
date.
L/L
date set <yyyy mm dd> Sets the system’s date. H/H
timeserver show Displays the system’s time server. M/L
timeserver set <none> Sets the system to not use a time
server.
H/H
timeserver set <daytime|time|ntp>
<ip> <utc[<+|-
>0100~1200]>
[nosync]
Sets the time service protocol,
time server’s IP address and the
device’s time zone.
H/H
timeserver sync Retrieves the date and time from
the time server.
H/H
log show Displays the device’s logs. M/L
log clear Clears the device’s logs. H/H
Table 92 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P