ZyXEL Communications IES-1248-51 - IGMP Filter Profile Delete Command; IGMP Filter Profile Show Command; Figure 187 IGMP Filter Profile Set Command Example; Figure 188 IGMP Filter Profile Delete Command Example

IES-1248-51/51A/53 User’s Guide
330 Chapter 50 IGMP Commands
This command configures an IGMP filter profile.
The following example configures an IGMP filter profile named voice with a range of
multicast IP addresses (index 1) from 224.1.1.10 to 224.1.1.44.
50.3.4 IGMP Filter Profile Delete Command
Syntax:
ras> switch igmpfilter profile delete <name>
where
This command removes an IGMP filter profile.
The following example removes the voice IGMP filter profile.
50.3.5 IGMP Filter Profile Show Command
Syntax:
ras> switch igmpfilter profile show [<name>|*]
where
This command displays an IGMP filter profile’s settings.
<endip> =
Type the ending multicast IP address for a range of IP addresses
that you want to belong to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both
the Start IP and End IP fields.
Figure 187 IGMP Filter Profile Set Command Example
ras> switch igmpfilter profile set test1 1 224.1.1.10 224.1.1.44
<name> =
The name of an IGMP filter profile.
Figure 188 IGMP Filter Profile Delete Command Example
ras> switch igmpfilter profile delete voice
[<name>|*] =
The name of an IGMP filter profile or all of the IGMP filter
profiles <*>.