ZyXEL Communications IES-1248-51 - Disable Command; Server Set Command; Server Delete Command

IES-1248-51/51A/53 User’s Guide
306 Chapter 47 DHCP Commands
This command turns on the DHCP relay feature.
47.1.3 Disable Command
Syntax:
ras> switch dhcprelay disable
This command turns off the DHCP relay feature.
47.1.4 Server Set Command
Syntax:
ras> switch dhcprelay server set <vid> <primary-server> [<secondary-
server>]
where
This command specifies the DHCP server(s) that serve the specified VLAN. The primary
server is required; the secondary server is optional. The IES-1248 routes DHCP requests to the
specified DHCP server(s) according to the
relaymode. See Section 47.1.7 on page 307.
Use VLAN ID 0 to set up the default DHCP server(s) for all non-listed VLAN.
47.1.5 Server Delete Command
Syntax:
ras> switch dhcprelay server delete <vid> [<primary-server>]
where
This command deletes all information about DHCP servers for the specified VLAN.
Afterwards, the specified VLAN can uses the default DHCP server(s) set up for VLAN ID 0,
if any.
<vid> =
The ID of the VLAN served by the specified DHCP server(s).
<primary-
server>
=
The IP address of one DHCP server.
<secondary-
server>
=
The IP address of a second DHCP server.
<vid> =
The ID of the VLAN served by the specified DHCP server(s).
<primary-
server>
=
The IP address of one DHCP server.