ZyXEL Communications IES-1248-51 - Chapter 36 Syslog; Syslog; Syslog Screen; Figure 123 Syslog

IES-1248-51/51A/53 User’s Guide
Chapter 36 Syslog 235
CHAPTER 36
Syslog
This chapter explains how to set the syslog parameters.
36.1 Syslog
The syslog feature sends logs to an external syslog server.
36.2 SysLog Screen
To open this screen, click Advanced Application, SysLog.
Figure 123 SysLog
The following table describes the labels in this screen.
Table 72 SysLog
LABEL DESCRIPTION
Enable Unix Syslog Select this check box to activate syslog (system logging) and then configure the
syslog parameters described in the following fields.
Syslog Server IP Enter the IP address of the syslog server. (The log facility is specified in Alarm >
Alarm Event Setup. See Section 39.4 on page 249.)
Apply Click Apply to save your changes to the IES-1248’s volatile memory. The IES-
1248 loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.