IES-1248-51/51A/53 User’s Guide
56 Chapter 3 Front Panel Connections
Figure 9 SFP Mini GBIC Slot
• Type: SFP connection interface
• Connection speed: 1 Gigabit per second (Gbps)
3.3.1 Transceiver Installation
Use the following steps to install a mini GBIC transceiver (SFP module) in the SFP slot.
Note: The SFP slot is at an angle. Do not attempt to straighten it.
1 Remove the dust cover from the transceiver.
2 For transceivers with a flip-up or flip-down latch, close the latch.
3 Insert the fiber-optic cables into the transceiver (you may need to remove cable dust
covers).
4 Insert the transceiver into the IES-1248’s SFP slot with the exposed section of PCB board
facing down.
5 Press the transceiver firmly until it clicks into place.
Figure 10 Transceiver Installation
To Next Page
Loading...
