IES-1248-51/51A/53 User’s Guide
Chapter 16 xDSL Port Setup 133
16.11 PPVC Setup Screen
Use this screen to view and configure PPVCs.
To open this screen, click Basic Setting, xDSL Port Setup, PPVC Setup.
Figure 64 PPVC Setup
The following table describes the labels in this screen.
1 -> level 1
0 > level 0
Table 22 IEEE 802.1p Priority to PPVC Mapping (continued)
IEEE 802.1 PRIORITY MAPS TO: PPVC 0/33, PRIORITY QUEUE
Table 23 PPVC Setup
LABEL DESCRIPTION
xDSL Port Setup Click xDSL Port Setup to go to the screen where you can configure DSL port
settings (see Section 16.7 on page 121).
VC Setup Click VC Setup to open the VC Setup screen where you can configure VC
settings for the DSL ports (see Section 16.9 on page 128).
Port Use this drop-down list box to select a port for which you wish to configure
settings.
Encap. Select the encapsulation type (llc or vc) for this PPVC.
VPI Type the Virtual Path Identifier for this PPVC.
VCI Type the Virtual Circuit Identifier for this PPVC. The IES-1248 uses this PVC
channel internally. This PVC is not needed on the subscriber’s device. This PVC
cannot overlap with any existing PVCs on this port.
PVID Type a PVID (Port VLAN ID) to assign to untagged frames received on this
PPVC.
To Next Page
Loading...
