ZyXEL Communications IES-1248-51 - VLAN CPU Set Command; Configuring Management VLAN Example; Figure 166 VLAN CPU Set Command Example; Figure 167 VLAN CPU Set Command Example

IES-1248-51/51A/53 User’s Guide
318 Chapter 48 IEEE 802.1Q Tagged VLAN Commands
This command displays the management VLAN (CPU). You can only use ports that are
members of this management VLAN in order to manage the IES-1248.
The following example sets VLAN ID 2 to be the CPU (management) VLAN.
48.4.7 VLAN CPU Set Command
Syntax:
ras> switch vlan cpu set <vid>
where
This command sets the management VLAN (CPU). You can only use ports that are members
of this management VLAN in order to manage the IES-1248.
The following example sets VLAN ID 2 to be the CPU (management) VLAN.
48.4.8 Configuring Management VLAN Example
Note: After the following example configuration, you must connect to the first Ethernet
port through a VLAN aware device that is using the proper VLAN ID in order to
perform management.
By default, the IES-1248’s ADSL ports are members of the management VLAN (VID 1). The
following procedure shows you how to configure a tagged VLAN that limits management
access to just one Ethernet port.
Note: Use the console port to configure the IES-1248 if you misconfigure the
management VLAN and lock yourself out.
1 Use the
switch vlan set command to configure a VLAN ID (VID 3 in this example)
for managing the IES-1248 (the “management” or “CPU” VLAN).
Figure 166 VLAN CPU Set Command Example
ras> switch vlan cpu set 2
<vid> =
The VLAN ID. Valid parameter range = [1 – 4094].
Figure 167 VLAN CPU Set Command Example
ras> switch vlan cpu set 2
Figure 168 CPU VLAN Configuration and Activation Example
ras> switch vlan set 3 enet1:FT