ZyXEL Communications IES-1248-51 - Chapter 39 Alarm; Alarm; Alarm Status Screen; Figure 130 Alarm Status

IES-1248-51/51A/53 User’s Guide
Chapter 39 Alarm 247
CHAPTER 39
Alarm
This chapter shows you how to display the alarms, sets the severity level of an alarm(s) and
where the system is to send the alarm(s) and set port alarm severity level threshold settings.
39.1 Alarm
The IES-1248 monitors for equipment, DSL and system alarms and can report them via SNMP
or syslog. You can specify the severity level of an alarm(s) and where the system is to send the
alarm(s). You can also set the alarm severity threshold for recording alarms on an individual
port(s). The system reports an alarm on a port if the alarm has a severity equal to or higher
than the port’s threshold.
39.2 Alarm Status Screen
This screen displays the alarms that are currently in the system.
To open this screen, click Alarm, Alarm Status.
Figure 130 Alarm Status
The following table describes the labels in this screen.
Table 80 Alarm Status
LABEL DESCRIPTION
Alarm Event Setup Click Alarm Event Setup to go to a screen where you can configure the severity
level of an alarm(s) and where the system is to send the alarm(s). See Section
39.4 on page 249.
Alarm Port Setup Click Alarm Port Setup to go to a screen where you can configure the alarm
severity threshold for recording alarms on an individual port(s). See Section 39.5
on page 252.
Alarm Type Select which type of alarms to display by Severity, or select All to look at all the
alarms.