IES-1248-51/51A/53 User’s Guide
298 Chapter 46 Alarm Commands
The following example displays the current critical level alarms for all alarm categories and
conditions.
The source is where the alarm originated. This is either a DSL port number, one of the
Ethernet ports (enet 1 or 2), or “eqpt” for the system itself.
46.4 Alarm Port Show Command
Syntax:
ras> alarm port show [<severity>|all]
This command displays port alarm severity level thresholds. The system reports an alarm on a
port if the alarm has a severity equal to or higher than the port’s threshold.
Figure 149 Alarm Show Command Example
ras> alarm tablelist
no alarm condition facility snmp syslog severity clearable
--- ------ ------------------------- --------- ---- ------ -------- -------
1 dsl ( 5000)line_up local1 V V info -
2 dsl ( 5001)line_down local1 V V minor V
3 dsl ( 5002)ad_perf_lol_thresh local1 V V info V
4 dsl ( 5003)ad_perf_lof_thresh local1 V V info V
5 dsl ( 5004)ad_perf_los_thresh local1 V V info V
6 dsl ( 5005)ad_perf_lop_thresh local1 V V info V
7 dsl ( 5006)ad_perf_es_thresh local1 V V info V
8 dsl ( 5007)ad_perf_rate_chg local1 V V info V
9 dsl ( 5008)ad_perf_ses_thresh local1 V V info V
10 dsl ( 5009)ad_perf_uas_thresh local1 V V info V
11 dsl ( 5010)ad_atuc_loftrap local1 V V minor -
12 dsl ( 5011)ad_atuc_lostrap local1 V V minor -
13 dsl ( 5012)ad_atur_loftrap local1 V V minor -
14 dsl ( 5013)ad_atur_lostrap local1 V V minor -
15 dsl ( 5014)ad_atur_lprtrap local1 V V minor -
16 eqpt ( 10000)vol_err local1 V V critical -
17 eqpt ( 10001)temp_err local1 V V critical -
18 eqpt ( 10002)fan_err local1 V V critical -
19 eqpt ( 10003)hw_rtc_fail local1 V V critical -
Press any key to continue, 'e' to exit, 'n' for nopause
To Next Page
Loading...
