IES-1248-51/51A/53 User’s Guide
162 Chapter 19 VLAN
Figure 77 VLAN Port Setting
The following table describes the labels in this screen.
Table 34 VLAN Port Setting
LABEL DESCRIPTION
VLAN Status Click VLAN Status to see which of the IES-1248’s ports are members of which
VLANs (see Section 19.3 on page 158).
Static VLAN Click Static VLAN to configure ports to dynamically join a VLAN group or
permanently assign ports to a VLAN group or prohibit ports from joining a VLAN
group (see Section 19.4 on page 160).
Port The port numbers identify the IES-1248’s ports.
PVID Type the Port VLAN ID (PVID) from 1 to 4094. The IES-1248 assigns the PVID
to untagged frames or priority frames (0 VID) received on this port.
Priority Select an IEEE 802.1p priority to assign to untagged frames or priority frames (0
VID) received on this port.
GVRP Select this check box if the IES-1248 should use GVRP to automatically register
and configure VLAN membership.
Acceptable Frame
Type
Select All to have the port accept both tagged and untagged incoming frames.
a
Select Tag Only to have the port only accept incoming frames that have a VLAN
tag.
Apply Click Apply to save your changes to the IES-1248’s volatile memory. The IES-
1248 loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
To Next Page
Loading...
