ZyXEL Communications IES-1248-51 - Chapter 21 Static Multicast; Static Multicast; Static Multicast Screen; Figure 87 Static Multicast

IES-1248-51/51A/53 User’s Guide
Chapter 21 Static Multicast 175
CHAPTER 21
Static Multicast
This chapter describes the Static Multicast screen.
21.1 Static Multicast
Use static multicast to allow incoming frames based on multicast MAC address(es) that you
specify. This feature can be used in conjunction with IGMP snooping/proxy to allow multicast
MAC address(es) that are not learned by IGMP snooping or IGMP proxy. Use static multicast
to pass routing protocols, such as RIP and OSPF.
21.2 Static Multicast Screen
To open this screen, click Advanced Application, Static Multicast.
Figure 87 Static Multicast
The following table describes the labels in this screen.
Table 42 Static Multicast
LABEL DESCRIPTION
The Number of
Static Multicast
This is the number of static multicast entries configured on the IES-1248.
Page X of X This identifies which page of information is displayed and the total number of
pages of information.