ZyXEL Communications IES-1248-51 - Page 272

IES-1248-51/51A/53 User’s Guide
272 Chapter 44 Commands
wdog show Displays the current watchdog
firmware protection feature status
and timer.
H/~
wdog set <msec|0:disable> Sets the watchdog count. 0 turns
the watchdog off.
H/~
monitor show Displays the hardware monitor’s
statistics.
L/L
monitor enable Turns the hardware monitor on. H/H
monitor disable Turns the hardware monitor off. H/H
monitor vlimit <idx> <high> <low> Sets the maximum (<high>) or
minimum (<low>) voltage at the
specified voltage sensor. You can
specify a voltage with up to three
digits after a decimal point (0.941
for example).
Normal voltage at each sensor:
Idx: 1=1.2v, 2=1.8v, 3=3.3v, 4=24v
H/H
monitor tlimit <idx> <high> <low> Sets the maximum (<high>) or
minimum (<low>) temperature at
the specified temperature sensor.
You can specify a temperature
with up to three digits after a
decimal point (-50.025 for
example).
Temperature sensor locations: Idx:
1=DSL, 2=CPU, 3=HW monitor
H/H
monitor flimit <idx> <high> <low> Sets the maximum (<high>) or
minimum (<low>) fan revs per
minute (RPM) at the specified fan
(<idx>).
Idx: 1=Fan 1, 2=Fan 2, 3=Fan 3.
H/H
monitor extalm <idx> <name> Set external alarm name. H/H
user online Displays online user info. M/~
user enable <name> Turns on the specified user name
of multi-login.
H/H
user disable <name> Turns off the specified user name
of multi-login.
H/H
user set <username>
<password>
<high|middle|low>
Creates or edits the password and
privilege level of the specified user
name.
H/H
user delete <name> Removes the specified user name
of multi-login.
H/H
user show Displays the authentication mode,
RADIUS server settings and user
info.
M/L
user auth <local|radius|land
r>
Set authentication method. H/H
Table 92 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P