IES-1248-51/51A/53 User’s Guide
136 Chapter 16 xDSL Port Setup
Add / Modify Click Add / Modify to save member PVC settings for a PPVC.
In order to change a member PVC ‘s settings, just enter the PVC’s VPI and VCI,
and configure the settings you want. These settings replace the PVC’s old
settings when you click Add / Modify.
Clicking Add / Modify saves your changes to the IES-1248’s volatile memory.
The IES-1248 loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Close Click Close to exit the screen without saving your changes.
Table 24 PPVC Setup, Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
