2gig Technologies Go Control - SIA CP-01 Defaults

Programming Navigation
©2013 2GIG Technologies Inc. All Rights Reserved.
23
3 EntertheInstallerCode(default=1561)to
displaytheInstallerToolbox.
4 PressSystemConfigurationandbegin"RF
SensorProgrammingStep
s"onpage30.
5 Usetheinstallationlogsheettorecord
programmedoptionsforthesystem.
6 Aftersettingalltherequiredprogramming
valuesforthesensorsandtheControlPanel,
pressEnd,thenExit,tosavethechanges.
7 AftertheControlPanelrestarts,pressSecurity
/Menu/Toolbox,entertheMasterUserCode
(default=1111),pressUserManagementand
setuptheuser’scodes.BesuretosetaDuress
CodeasUser#8.PressBackwhenfinished.
8 PressBrightness/Volumeandsetthelevelsfor
theinstallation.
9 Thevolumesettingdoesnotaffectthevolume
ofalarmsounds.
10 Press→toviewthesecondtoolboxscreen.
11 PressBackLightTimeoutandsetthedisplay
lightingtimeout.
12 PressSetDat eandSetTimeandsetthe
calendarandclock.IftheCellRadioModuleis
installed,thedateandtimesetsautomatically.
13 Pressthe buttontoreturntotheHome
Screen.
Aftercompletingallsetupand
programming,refer
totheUserGuidefordetailsonoperatingthe
system.Checkofftheprogrammedoptionsforthe
systemintheUserGuide.
NOTE: Besuretoinstructthesubscriberon
theproperoperationofthesystem,and
leavetheUserGuideattheinstallation
siteforreference.
SIA CP-01 Defaults
Severalsystemprogrammableoptionshavethe
defaultspre‐settoprovidecompliancewiththe 
SecurityIndustryAssociationCP‐01Standard.All
othersystemsettingsandfunctionsthatare
requiredtocomplywithSIACP‐01ar epermanently
programmedintotheConsoleandcannotbe
changed.Refertothetableforeachpr
ogrammable
optionthathasareq
uiredSIACP‐01programming
default.
ProgrammingQuestion SIACP‐01Default Range
Q‐1WirelessSensorDialerDelay 30Seconds OnorOff
Q‐2WiredSensorDialerDelay 30Seconds OnorOff
Q‐5ExitDelay 60Seconds 45‐120Seconds
Q‐6EntryDelay#1 30Seconds 30‐240Seconds
Q‐7EntryDelay#2 45Seconds 30‐240Seconds
Q‐10CallWaitingDisableCode NoDefaultCode 0‐6Digits
Q‐20SwingerShutdownCount 2Trips 1‐6Trips
Q‐26AutoStay Enabled EnabledDisabled
Q‐27ExitDelayRestart Enabled EnabledorDisabled
Q‐31CancelTime 5Minutes 6‐254Minutes
Q‐32CancelDisplay Enabled EnabledorDisabled
Q‐35AbortWindowDialerDelay 30Seconds 15or45Seconds
Q‐79SelectOutput FollowsInternalSounder SeeQ‐78forOptions