2gig Technologies Go Control - Wired Sensor Programming Screen

34 ©2013 2GIG Technologies Inc. All Rights Reserved.
Go!Control Wireless Security System | Install Guide
1 Scrollbetweenoponsusingthe←and→
arrows.Movetothepreviousornextprompt
bypressingthe↑and↓arrows.
2 Toprogramanothersensorclicknext.
3 Toexitprogramming,clickskipthenendand
exit. Uponexit,the paneltak e saseveral
secondstoreboot.
Wired Sensor Programming Screen
Aftersettingalltheoptionsforasensor,thewired
sensorsummaryscreenisdisplayed.Thescreen
canalsobedisplayedforprogrammedsensors
duringwiredsensorprogrameditingbypressing
theSumbutton.
•Whilepr
ogra
mmingeachwiredsensor
rememberthatthe←and→arrowbuons
stepthrougheachofthewiredsensor
numbers.
•Tore
turntoprogr
amming,clicktheedit
currentoreditnextbuttons.
• Pressingskipgoestoques
tionnumberQ‐3(RF
KeyFobProgramming).See"RFKeyFob
Pr
ogramming"onpage37.
NOTE: Forthedetailedstepsofprogramming
awiredsensor,seethefollowingpage.