2gig Technologies Go Control - Restoring Programming Defaults; Restore Defaults

60 ©2013 2GIG Technologies Inc. All Rights Reserved.
Go!Control Wireless Security System | Install Guide
2 EntertheMasterUserCodetoproceedwith
thetest.
3 TheTelephoneTestscreenappears.Thetop
portionofthescreenshowstheactionsthat
theControlPanelistaking.Thebottom
portionofthescreenshowstheresultsofthe
actions.Scrollthroughthestatusscreenwith
the↓and↑arrows.
4 Whenthetestiscomplete,pressOktoreturn
totheToolbox.
RESTORING PROGRAMMING
DEFAULTS
TosoftresettheControlPanelbacktothefactory
defaults,usetheRestoreDefaultoptioninthe
Installertoolbox.
NOTE: TheControlPanelmayalsobe“hard”
resettoout‐of‐the‐boxfactorydefaultsby
pressingandholdingtheemergencyand
homebuttonswhileapplyingpower(if
notdisabledthroughprogramming
questionsQ‐44&Q‐45).
Restore Defaults
TheRestoreDefaultsscreenprovidesamethodto
selectivelyresettheControlPaneltoitsdefault
programmingvaluesinsteadofusingafullhard
reset.Twocheckboxoptionsareavailable(oneor
bothmustbechecked):
•IftheZo
n
esboxischecked,alldataforthe48
sensorswillbeerasedandreplacedwiththe
defaultvalues.
•IftheConso
leboxischecked,alltheControl
Panelprogrammingquestions(exceptZ‐Wave
questionsQ79‐Q83)willbeerasedand
replacedwiththedefaultvalues:
•TheUs
erCo
deswillbeerased
•Thebacklighttimeout
willberesettofive
minutes
• Brightness/Volumeset
tingswillbereset